Ansi asq z1 9 2008 pdf12/31/2022 All requests should be in writing to the attention of the Standards Administrator at the address below. ASQ will consider requests for change and information on the submittal of such requests regarding this Standard. All requests pertaining to the ANSI/ASQ Z1.9-2003 Standard should be submitted to ASQ. No part of this publication may be reproduced in any form, including an electronic retrieval system, without the prior written permission of ASQ. This Standard is subject to copyright claims of ANSI, and ASQ. ©2003 by ASQ Copyright protection notice for the ANSI/ASQ Z1.9-2003 Standard. Purchasers of American National Standards may receive current information on all standards by calling or writing the American National Standards Institute. Thethis procedures American Standards InstituteNational require Standard that actionmay be taken to reaffirm, revise, or withdraw standard of nothe later than five years from the date of publication. CAUTIONNational NOTICE: This American be revised or withdrawn at any time. American National Standards are subject to periodic review and users are cautioned to obtain the latest edition. The existence of an American National Standard does not in any respect preclude anyone, whether he has approved the standard or not, from manufacturing, marketing, purchasing, or using products, processes, or procedures not conforming to the standard. An American National Standard is intended as a guide to aid the manufacturer, the consumer, and the general public. AMERICAN NATIONAL STANDARD: An American National Standard implies a consensus of those substantially concerned with its scope and provisions. It is applicable only when the normality of the measurements is assured. Variation may be measured by sample standard deviation, sample range, or known standard deviation. It provides tightened, normal, and reduced plans to be used on measurements which are normally distributed. SAMPLING PROCEDURES AND TABLES FOR INSPECTION BY VARIABLES FOR PERCENT NONCONFORMINGĪCCREDITED STANDARDS COMMITTEE Z1 SUBCOMMITTEE ON STATISTICSĪBSTRACT Sampling Procedures and Tables for Inspection by Variables for Percent Nonconforming is an acceptance sampling system to be used on a continuing stream of lots for AQL specified. AMERICAN NATIONAL STANDARD SAMPLING PROCEDURES AND TABLES FOR INSPECTION BY VARIABLES FOR PERCENT NONCONFORMINGĪMERICAN SOCIETY FOR QUALITY 600 NORTH PLANKINTON AVENUE MILWAUKEE, WISCONSIN 53201įile:///Users/satishkulkarni/Downloads/69c3370879563c1ec5da717e.html
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |